1946-1962 Willys Overland Jeep Wagon and Pickup Truck
Front Floor Panels
- Die Formed
- 18 gauge steel
- Driver full length panel shown. Passenger sides available. Short version also available.
- Steering Column and Pedal area are left intact to allow for customization.
- Extra material provided on the inboard side for use if needed.
- Our panel threshold area is properly curved from front to back which allows for a proper rocker panel fit.
- Maximum panel width 24 inches.
- None of our panels are cosmetically coated. Click here to find out why.
- Made in the USA
$95.00 Driver Short Panel
$95.00 Passenger Short Panel
$135.00 Driver Full Length Panel
$135.00 Passenger Full Length Panel
More Information and Add to Cart Options
Floor Supports
1946-1962 Willys Overland Jeep Wagon and Pickup Truck
- Die Formed
- 16 Gauge Steel
- None of our panels are cosmetically coated. Click here to find out why.
- Made in the USA
A. Front Pillar Support (Top)
$55.00 Driver
$55.00 Passenger
$110.00 Pair
More Information and Add to Cart Options
B. Rear Channel Support (Bottom)
$30.00 Driver
$30 Passenger
$60.00 Pair
A. Pillar Support (Top) B. Rear Channel (Bottom)
Pickup Truck Box Floors
Willys Overland Jeep
Stamped as shown in 16 gauge steel as was original. Not of original Jeep stamped corrugation but much better than flat steel or wood as a replacement. Made in 2 pieces overlapping at the center. (Same as Studebaker). Length measurement required by telephone (715)-537-5422 or e-mail Mark@ClassicEnt.com.
- None of our panels are cosmetically coated. Click here to find out why.
- Made in the USA
$475.00 Each
*There is an additional $95.00 UPS oversize surcharge that is added to our normal 10% shipping charge.
